OBD2 Cable for VAD15 - Universal
OBD2 Cable for VAD15 - Universal

OBD2 Cable for VAD15 - Universal

Regular price$55.00
/

  • $12 flat rate shipping to USA & Canada
  • Developed by the talented team at CANchecked
  • Made in Germany
  • In stock, ready to ship
  • Inventory on the way

This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.

This is the VADpro OBD II cable for the VAD15. With it the installation is done in a few minutes all OBD 2 values can be shown on the display! Also engine error codes can be displayed!

OBD2 socket assignment
OBD pin description Display pin
1 * Terminal 15 (ignition plus - not all vehicles) A5
4 + 5 Dimensions A1
6th Can high B2
14th Can Low B3
16 Permanent plus (12V)  

* If the CC22720 cable is used, pins 1 and 16 are not assigned, but are led out as a separate cable.

Can bus

The Can Bus settings must match the vehicle. By default, these are set that fit most vehicles:

  1. "Settings": Speed ​​= 500, CanTerm = ON

The display tests itself whether 11bit (Can2.0A) or 29bit (Can2.0b) identifiers are supported by the control unit.

Supported values

These values ​​are preset and cannot be changed:

  • Speed ​​(RPM)
  • Engine load
  • Fuel Pressure
  • Boost pressure (MAP)
  • Vehicle speed
  • Ignition angle (IgnAng)
  • Intake temperature (IAT)
  • Air mass (MAF)
  • Oil temperature (OilTemp)
  • Fuel pressure relative to inlet vacuum (FuelRail)
  • Water temperature (CLT)
  • Lambda1-8
  • Cat temperature bank1 sensor 1 (CatTemp1)
  • Cat temperature bank1 sensor 2 (CatTemp2)
  • Cat temperature bank2 sensor 1 (CatTemp3)
  • Cat temperature bank2 sensor 2 (CatTemp4)
  • Additionally 4 analog inputs

Analog inputs

In addition to the OBD2 values, sensors can also be fed in via the four analog inputs. More about this here:  Analog inputs


Recently viewed